Skip to main content

Full text of "PSP 3000 Repair Manual"

See other formats


Installing PSP 3000 Casing 



Installing PSP 3000 Casing 



Tools used in this guide 

• Phillips #00 Screwdriver 

• Spudger 




Step 1 - Battery 

• Start on the back of the device. This is where the 
battery and the battery cover are located. 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 1 of 4 



Installing PSP 3000 Casing 




Step 2 

• The battery door is located on the left side when 
looking at the PSP from the back. Lift open the battery 
door to reveal the battery. Remove the battery cover. 

• Using your finger, pry up the top edge of the battery. 
Continue to pull the top edge until the bottom of the 
battery is free. 

• Remove the battery. 




Step 3 - Casing 

• Using a spudger or fingernail, peel back the warranty 
sticker that is behind the battery. 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 2 of 4 



Installing PSP 3000 Casing 




Step 4 

• Unscrew all four screws from the back of the PSP. 

• Two from behind the battery. 

• Two on the right side of the PSP. 




Steps 

• Unscrew two screws from the top of the PSP. 



© 2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 3 of 4 



Installing PSP 3000 Casing 




Step 6 

• Remove a single screw from the bottom surface of the 
PSP. 




Step? 

• Starting from the 'R' trigger, slide the spudger in 
between the outer casing the the PSP, and gently pry 
off the casing. 

• Remove the front casing completely. 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 4 of 4